Juniper TX MATRIX PLUS, Hardware Manual

Page: 490 / 502

Packing the TX Matrix Plus Router for Shipment
To pack the TX Matrix Plus router for shipment:
1.
Retrieve the shipping crate and packing materials in which the TX Matrix Plus router
was originally shipped. If you do not have these materials, contact your Juniper
Networks representative about approved packaging materials.
2.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
3.
On the console or other management device connected to the master Routing Engine,
enter CLI operational mode. To shut down the TX Matrix Plus router software:
user@host> request system halt sfc 0
Halt the system ? [yes,no] (no) yes
*** FINAL System shutdown message from user@host ***
System going down IMMEDIATELY
Terminated
...
syncing disks... 11 8 done
The operating system has halted.
Please press any key to reboot.
NOTE: The request system halt sfc 0 command halts all Routing Engines
on the control plane from which it was issued. To reboot a Routing Engine
that has been halted, you must connect through the console. For more
information about system commands, see the Junos OS System Basics
and Services Command Reference.
4.
Shut down power to the TX Matrix Plus router by pressing the circuit breakers for all
power supplies to the off (
O ) position.
5.
Disconnect power from the TX Matrix Plus router.
6.
Remove the cables that connect to all external devices.
7.
Remove all fiield-replaceable units (FRUs) from the TX Matrix Plus router.
8.
Remove the TX Matrix Plus router from the rack by placing the mechanical lift router
under the TX Matrix Plus router, unscrewing and removing the mounting screws from
the rack, and moving the TX Matrix Plus router to the shipping crate.
9.
Place the TX Matrix Plus router in the shipping crate or onto the pallet. If on a pallet,
bolt the TX Matrix Plus router to the pallet.
10.
Cover the TX Matrix Plus router with an ESD bag and place the packing foam on top
of and around the TX Matrix Plus router.
11.
Replace the accessory box on top of the packing foam.
Copyright © 2010, Juniper Networks, Inc. 456
TX Matrix Plus Router Hardware Guide