Juniper SRX220, Hardware Manual

Page: 125 / 182

Table 39: Component LEDs on the Services Gateway
Possible Causes and
Corrective Actions
Meaning State LED
Normal condition. No action
is required. The device is functioning
normally. Green Status
Normal condition. No action
is required. • The device is starting up.
• The Reset Config button
is pressed.
Amber
Contact the Juniper
Networks Technical
Assistance Center (JTAC).
See
“Juniper Networks
Technical Assistance
Center” on page 113
.
An error is detected in the
device. Red
A major alarm indicates a
critical situation on the
gateway that requires
immediate action.
See “Monitoring the
SRX220 Services Gateway
Using Chassis Alarm
Conditions” on page 109
.
The device detects a major
alarm. Red Alarm
A minor alarm requires
monitoring or maintenance.
If left unchecked, it might
cause an interruption in
service or degradation in
performance.
See “Monitoring the
SRX220 Services Gateway
Using Chassis Alarm
Conditions” on page 109
.
The device detects a minor
alarm. Amber
Normal condition. No action
is required. The device is starting up.
NOTE: If the system is up
and running and the Alarm
LED is off, it indicates that no
alarms are present on the
device.
Off
107 Copyright © 2016, Juniper Networks, Inc.
Chapter 18: Troubleshooting Components