Juniper SRX220, Hardware Manual

Page: 101 / 182

Connecting an SRX220 Services Gateway to the CLI Locally
If you plan to use the command-line interface (CLI) to configure the SRX220 Services
Gateway, you must connect through the console port, as shown in
Figure 20 on page 83 .
Figure 20: Connecting to the Console Port on an SRX220 Services Gateway
g037614
NOTE: The numbers in Figure 20 on page 83 correspond to the numbers in
Table 33 on page 83 .
Table 33: Connecting to the Console Port on an SRX220 Services Gateway
Component Number
Console port on services gateway 1
RJ-45 cable 2
DB-9 to RJ-45 adapter 3
Serial port on management device 4
NOTE: Figure 20 on page 83 shows a connection to a local management
device. A remote connection to the services gateway through a modem
requires the cable and connector shown (provided in the services gateway
accessory box), plus a DB-9 male to DB-25 male (or similar) adapter for your
modem, which you must purchase separately.
83 Copyright © 2016, Juniper Networks, Inc.
Chapter 16: Performing Initial Configuration