Juniper QFX5100, Hardware Manual

Page: 215 / 256

4.
Remove the power source cable from the power supply faceplate:
•
AC power supply—Remove the power cord from the power supply faceplate by
detaching the power cord retainer and gently pulling out the female end of the
power cord connected to the power supply faceplate.
• DC power supply—Remove the screws securing the ring lugs attached to the power
source cables to the power supply using the screwdriver, and remove the power
source cables from the power supply. Replace the screws on the terminals and
tighten them.
5.
Slide the locking lever toward the handle until it stops.
6.
Grasp the power supply handle and pull firmly to slide the power supply halfway out
of the chassis.
7.
Place one hand under the power supply to support it and slide it completely out of
the chassis. Take care not to touch power supply components, pins, leads, or solder
connections.
8.
Place the power supply in the antistatic bag or on the antistatic mat placed on a flat,
stable surface.
Figure 51: Removing a Power Supply from a 1 U QFX5100 Switch
g050269
QFX5100-48S
RUNNING
JUNOS
Figure 52: Removing a Power Supply from a QFX5100-96S Switch
g050323
Related
Documentation
AC Power Supply for a QFX5100 Switch on page 35
•
•
Connecting AC Power to a QFX5100 Switch on page 173
•
Connecting DC Power to a QFX5100 Switch on page 176
•
Installing a Power Supply in a QFX5100 Switch on page 194
197 Copyright © 2014, Juniper Networks, Inc.
Chapter 20: Replacing Components