Juniper QFX5100, Hardware Manual

Page: 204 / 256

6.
(Optional) Configure the name of the switch. If the name includes spaces, enclose
the name in quotation marks (“ ”).
[edit]
root@#
set system host-name host-name
7.
Configure the default gateway.
[edit]
root@#
set routing-options static route default next-hop address
8.
Configure the IP address and prefix length for the switch management interface.
[edit]
root@#
set interfaces em0 unit 0 family inet address address/prefix-length
CAUTION: Although the CLI permits you to configure two management
Ethernet interfaces within the same subnet, only one interface is usable
and supported.
NOTE: The management ports,
em0
(
C0
) and
em1
(
C1
) are found on the
FRU end of the QFX5100 switch.
9.
(Optional) Configure the static routes to remote prefixes with access to the
management port.
[edit]
root@#
set routing-options static route remote-prefix next-hop destination-ip retain
no-readvertise
10.
Enable telnet service.
[edit]
root@#
set system services telnet
NOTE: When Telnet is enabled, you cannot log in to a QFX5100 switch
through Telnet using root credentials. Root login is allowed only for SSH
access.
11.
Commit the configuration to activate it on the switch.
[edit]
root@#
commit
Related
Documentation
•
Installing and Connecting a QFX5100 Switch on page 161
Copyright © 2014, Juniper Networks, Inc. 186
QFX5100 Switch Hardware Guide