4.
Either remove the failing SFB (see
"Remove an MX10004 Switch Fabric Board" on page 180
) or
remove the cover by grasping each side of the plate and pulling straight out (see
).
Figure 76: Remove an SFB Cover on an MX10004
5.
Remove the protective plastic covers that are on the fabric interface connectors of the SFB. Save
the plastic covers for future use (see
).
Figure 77: Remove Protective Plastic Covers from JNP10004-SF2 SFB Interface Connectors
6.
Lift the SFB by the handle with one hand and support the lower edge with the other hand.
7.
Hold the SFB vertically and slide the SFB into the open slot until the ejector handles engage and
start to close.
178
