JUNOSe 11.0.1 Release Notes
52
Known Problems and Limitations
ERX7xx model, ERX14xx model, or ERX310 router:
When you use the
ping
command with the IPv6 address of the helper
router in the multicast area as the destination address and the
loopback address of the helper router in the backbone area as the
source address, a packet loss of 2 seconds occurs for the first stateful
SRP switchover. However, no packet loss occurs for successive stateful
SRP switchovers.
When you use the
ping
command with the IPv6 address of the helper
router in the broadcast network as the destination address and no
source address when stateful SRP switchover is performed the first
time, an identical packet loss occurs. In this case too, no packet loss
occurs during subsequent switchovers.
E120 router or E320 router
When you use the
ping
command with the IPv6 address of the helper
router in the broadcast network as the destination address and the
loopback address of the helper router in the backbone area as the
source address, no packet loss occurs.
When you use the
ping
command with the IPv6 address of the helper
router in the multicast area as the destination address and no source
address, a packet loss of 1–2 seconds sometimes occurs during stateful
SRP switchovers.
Subscriber Management
When a dynamic GRE tunnel interface for Mobile IP relocates between SM
modules because the original SM reloads, Mobile IP deletes the relocated tunnel
interface. [Defect ID 178399]
When a subscriber has subscribed for a service, service session accounting
records always contains a default Acct-Terminate-Cause value of 10. This value
remains unchanged even after you use the
terminate-code
command to
configure a custom mapping between application terminate reasons and
RADIUS Acct-Terminate-Cause attributes. [Defect ID 181043]
Dynamic subscriber interfaces continue to remain in the down or not present
operational state in either of the following scenarios: [Defect ID 81269]
If you configured a dynamic interface column, such as a dynamic bridged
Ethernet interface, dynamic VLAN interface, or an ATM interface, and when
any one of the following conditions is satisfied:
The major interface is bounced (shut down and reenabled)
The major interface is shut down, which cause the dynamic VLAN
interfaces to be removed
The physical link goes down and comes back up
The line module is removed and reinserted
