Release Highlights
7
Release 11.0.1
Release Highlights
Release 11.0.1 is a maintenance release and includes the feature described in this
section.
SDX Software and SRC Software
Transfer of Calling Station ID to PDP
JUNOSe Software now supports sending of the calling station ID to the Policy
Decision Point (PDP) for a virtual router. To enable this functionality, use the
sscc option send-calling-station-id
command in Global Configuration mode.
The following command has been modified in this release:
The output of the following command has been modified in this release:
Change in existing behavior
: New feature added as described here.
Early Field Trial Features
The features described in this section are present in the code but have not yet been
fully qualified by Juniper Networks. These features are available only for field test
purposes in this release. If you use any of these features before they have been fully
qualified, it is your responsibility to ensure that the feature operates correctly in
your targeted configuration.
ANCP
Support for Learning the Partition ID from an Access Node
ANCP running on a network access server (NAS) can now learn the partition ID
from an access node and use this partition ID to communicate with the access
node. In lower-numbered releases, ANCP running on a NAS did not keep track
of the partition ID of an access node, and always communicated with partition
ID 0. This learning option in the virtual router enables the NAS to learn the
partition ID from all the access nodes. The learned partition ID can be used to
send messages to establish adjacency.
To learn the partition ID, the NAS has to wait until it receives the first
GSMP_SYN message from an access node.
The following command has been added to enable the learning option in the
global mode:
wait-for-gsmp-syn
Category
Feature
SDX Software and SRC
Software
Transfer of Calling Station ID to PDP on page 7
sscc option
show sscc option
