JUNOSe 11.0.1 Release Notes
2
Release Installation
Upgrading from Release 5.1.1 or Lower-Numbered Releases to
Release 6.x.x or Higher-Numbered Releases
Release 5.1.1 or lower-numbered releases support application images only up to
172 MB. Your software upgrades or application images may be available remotely
through Telnet or FTP, or may be delivered on a new NVS card. If you upgrade the
JunosE Software using a new NVS card, we recommend you perform the upgrade in
two stages: first to an intermediate release and then to the higher-numbered
release you want to run. This restriction is not applicable if you upgrade your
software remotely through Telnet or FTP.
To install larger application images for Release 6.0.0 and higher-numbered
releases, you must first install Release 5.1.2 (or a higher-numbered 5.x.x release).
This enables the system to support application images greater than 172 MB. For
example, if you are upgrading the software using a new NVS card, you cannot go
from Release 5.1.1 to Release 7.2.0 without first upgrading to Release 5.1.2.
See the following table for compatibility of releases
For more detailed information on installing software, and about NVS cards and SRP
modules, see the following documents:
JUNOSe System Basics Configuration Guide, Chapter 6, Managing Modules
Upgrading NVS Cards on SRP Modules
in
ERX Hardware Guide, Chapter 8,
Maintaining ERX Routers
Upgrading NVS Cards on SRP Modules
in
E120 and E320 Hardware Guide, Chapter
8, Maintaining the Router
Moving Line Modules Between Releases
The Juniper Networks ERX1440 Broadband Services Router employs a 40-Gbps SRP
module and a new midplane. Release 3.3.2 was the first software release to support
the 40-Gbps SRP module and midplane. Before you can transfer a compatible line
module from a Juniper Networks ERX705, ERX710, or ERX1410 Broadband
Services Router to an ERX1440 router, you must first load Release 3.3.2 or a higher
release onto the current router, and then reboot the router to load the release onto
the line modules. If you then move any of those line modules to an ERX1440
router, that router is able to recognize the line module.
If you move a compatible line module from an ERX1440 router to an ERX705,
ERX710, or ERX1410 router, the module loads properly in the new router
regardless of the release.
JUNOSe Release
Highest Release Able
to Load
Cannot Load
Maximum
Application Image
5.1.1 or lower-numbered
release
5.3.5p0-2 or the
highest-numbered 5.x.x
release
6.x.x or
higher-numbered
release
~172 MB
5.1.2 or
higher-numbered release
No limitation
Not applicable
~234 MB
7.2.0 or
higher-numbered release
No limitation
Not applicable
~256 MB
