Jungheinrich ECE 118, Operating Instructions Manual

Page: 33 / 81

0406
.GB
E 6
4.2 Driving, steering, braking
F
Full attention is required when driving and steering, especially when outside of
the truck envelope.
In walk-along mode make sure you have sufficient distance from the truck.
Emergency Off
– Remove the battery connector (13). All electrical functions are shut down.
Emergency Stop
Automatic braking (emergency stop) occurs when the tiller (5) is released – the tiller
automatically reverts to the upper brake zone (B).
F
If the tiller moves only slowly to the brake zone, the cause of the fault must be
rectified. If necessary, replace the return spring.
Travel
We distinguish between two travel modes:
– Rider mode (the operator platform is occupied): the truck can be operated at
maximum travel speed.
– Pedestrian mode (optional); (the operator platform is not occupied): The truck can
only be operated at the reduced travel speed (crawl speed).
General:
– Stand on the operator platform (14).
– Set the tiller (5) to the travel zone (F).
– Turn the controller (4) to the required direction V (fwd.) or R (rev.).
F
Do not drive the truck unless the panels are closed and properly locked. When
travelling through swing doors etc., take care to prevent the doors from actuating
the collision safety switch (3).
– Start up the truck (see Section 3).
0406
.GB
E 6
4.2 Driving, steering, braking
F
Full attention is required when driving and steering, especially when outside of
the truck envelope.
In walk-along mode make sure you have sufficient distance from the truck.
Emergency Off
– Remove the battery connector (13). All electrical functions are shut down.
Emergency Stop
Automatic braking (emergency stop) occurs when the tiller (5) is released – the tiller
automatically reverts to the upper brake zone (B).
F
If the tiller moves only slowly to the brake zone, the cause of the fault must be
rectified. If necessary, replace the return spring.
Travel
We distinguish between two travel modes:
– Rider mode (the operator platform is occupied): the truck can be operated at
maximum travel speed.
– Pedestrian mode (optional); (the operator platform is not occupied): The truck can
only be operated at the reduced travel speed (crawl speed).
General:
– Stand on the operator platform (14).
– Set the tiller (5) to the travel zone (F).
– Turn the controller (4) to the required direction V (fwd.) or R (rev.).
F
Do not drive the truck unless the panels are closed and properly locked. When
travelling through swing doors etc., take care to prevent the doors from actuating
the collision safety switch (3).
– Start up the truck (see Section 3).