eNet radio dimming actuator 1-gang mini
￭
Perform commissioning.
In installation positions that are not easily accessible, turn the operating mode switch to
position PC after commissioning and performing a function test. Subsequent changes to
the device settings can thus be carried out with the aid of the eNet Server without in-
volving excessive installation work.
The light can be switched by briefly pressing the Prog button.
Status-LED (3) lights up: switched on
Status LED (3) off: switched off
￭
Mount the cover.
Reset the overheating protection / short-circuit protection
If the electronic overheating or short-circuit protection has been activated, separate the dimmer
from the grid.
4.2 Commissioning
DANGER!
Electrical shock when live parts are touched.
Electrical shocks can be fatal.
During commissioning, cover the parts carrying voltage on radio transmitters and
actuators and in their surrounding area.
The actuator can also be commissioned with eNet Server as an alternative to the commis-
sioning described here.
Connecting with radio transmitter
Load is switched off.
￭
Press button Prog (2) for longer than 4 seconds.
The status LED (4) flashes after 3 seconds. The actuator is in programming mode for
approx. 1 minute.
￭
Switch radio transmitter to programming mode (see radio transmitter instructions).
￭
Trigger telegram on the radio transmitter.
The status LED (3) lights up for 5 seconds.
The actuator is connected to the radio transmitter. The actuator and radio transmitter exit
the programming mode automatically.
If the status LED of the actuator flashes 3 times at 1-second intervals for approx.
5 seconds, then the programming operation was not successful. All the memory locations
in the actuator or radio transmitter are occupied.
All On and All Off buttons of a radio transmitter are connected to the actuator automatic-
ally as soon as the first connection to a radio transmitter takes place. Scene buttons must
be connected separately.
Disconnecting connection to a radio transmitter
￭
Carry out the same steps as when connecting (see Connecting to radio transmitter).
The status LED (3) flashes quickly for 5 seconds. The actuator is disconnected from the
radio transmitter. The actuator and radio transmitter exit the programming mode automat-
ically.
If there several connections or scene buttons for a radio transmitter, all connections must
be disconnected individually.
4 / 16
82580733
14.10.2019
J0082580733
