eNet radio dimming actuator 1-gang mini
Parameters
Setting options, Basic setting
Explanations
%, then the system dims to
the set minimum brightness
when the hotel function is ac-
tivated.
Information window
In the Information window, the load can be controlled and the information about the device can
be displays.
Channel control/channel information
Display value
Explanations
Current dimming value
The load can be dimmed using the slider or a
brightness value entry.
Load state
The load can be switched on or off.
Restraint
Display of forced position status.
Operating hours
Display of the operating hours since the last
restart in the Settings window Einstellungen.
Display dimming principle
Display of the used dimming principle.
7
Troubleshooting
Connected LED lamps or compact fluorescent lamps switch off in the lowest dimming position
or flicker
The set minimum brightness is too low.
Increase minimum brightness.
Connected LED lamps or compact fluorescent lamps flicker
Cause 1: Lamps are not dimmable.
Check manufacturer's instructions.
Exchange lamps for another type.
Cause 2: Dimming principle and lamps do not optimally match.
Check operation in another dimming principle, reduce connected load as well if neces-
sary.
Connected LED lamps or compact fluorescent lamps in the lowest dimming position are too
bright; dimming range is too small
Cause 1: The set minimum brightness is too high.
Reduce minimum brightness.
Cause 2: HV-LED trailing edge phase control dimming principle does not optimally match the
connected HV-LED lamps.
Check operation in the "HV-LED leading edge phase control" setting, reduce connected
load as well if necessary.
Exchange lamps for another type.
Dimmer has switched off, status LED (3) flashes 3 times at intervals of 1 second
Cause 1: Operating mode switch (2) was set to another dimming principle.
The dimming principle was accidentally adjusted: Reset the original dimming principle on
the operating mode switch (see section 5.1. Mounting and Electrical Connection).
The dimming principle was intentionally adjusted: Check whether the dimming principle
matches the connected load. Switch mains voltage off and on again, the dimmer assumes
the new setting.
14 / 16
82580733
14.10.2019
J0082580733
