picture 12: Removing the slide switch
o
Remove slide switch (4) Do this by reaching with a screwdriver into the recesses provided
in the cover (picture 12).
picture 13: Removing the design cover
o
Remove design cover (11). Do this by reaching with a screwdriver into the point behind the
design cover marked with a screwdriver symbol (picture 13) and lift out.
o
Slacken screw (13) and pull motion detector cover off of the insert.
AS, A ranges and SL 500:
o
Remove the motion detector cover from the insert by hand.
Expanding the detection area
To expand the detection area, connect a 3-wire extension insert with motion detector cover. The
motion detector of the main unit also evaluates motion signals of the extension and, if
necessary, switches the lighting on.
o
Connect extensions (see instructions for 3-wire extension insert).
i
The sensitivity of motion detectors on extensions can be set individually. The run-on time
and the brightness threshold are only evaluated by the main device. The operating mode
switch on the extension has no function.
i
Do not connect any main units in parallel.
11/14
32540233
J:0082540233
26.07.2010
Light Management
Automatic switch 180° 1.10 m
