Changing the brightness threshold with the Teach function
The Teach function can be used to save the current ambient brightness as a brightness
threshold. The value set on the Brightness setter (6) is then no longer evaluated. Additional
saving operations overwrite the previous value.
i
A power failure of more than 2 seconds or changing the brightness adjuster (6) by at least
a half turn causes the loss of the saved brightness threshold.
i
If a brightness value of more than 80 lux is saved as the brightness threshold, then the
motion detector is in Day mode and switches irrespectively of the brightness.
picture 7: Activating the Teach function
o
Activating the Teach function: completely cover the motion detector three times within
9 seconds .
The Teach function is active. As confirmation, the switched-off lighting is switched on for
approx. 3 seconds or switched-on lighting switched off and then switched on for
approx. 3 seconds.
o
Move away from the motion detector for the next minute, so that it can measure the current
brightness without being shaded.
For confirmation of saving the lighting is switched on for 3 seconds.
The motion detector then switches to the set operating mode.
Setting the sensitivity
The motion detector possess automatic adjustment to the ambient conditions. Normally, the
adjuster
Sens.
should be set to maximum sensitivity.
o
Remove slide switch (4).
o
Set the sensitivity using the adjuster
Sens.
(6).
o
Snap on slide switch.
i
If there are unwanted switching operations, reduce the sensitivity.
Set run-on time
The run-on time can be set in a range from approx. 10 seconds to approx. 30 minutes. The
setting is non-linear, longer times are specified in a more rough framework.
o
Remove slide switch (4).
o
Set the required run-on time using the run-on time adjuster (8).
o
Snap on slide switch.
i
If a dimmer insert is used, then dimming will take place after the run-on time has elapsed
and the lighting will switch off after approx. 30 seconds. If, during dimming, movement is
detected, then the motion detector switches back to switch-on brightness.
7/14
32540233
J:0082540233
26.07.2010
Light Management
Automatic switch 180° 1.10 m
