Save switch-on brightness
The light is switched to this brightness value on each switch-on. In the as-delivered state, the
switch-on brightness is set to the maximum brightness.
Motion detector cover is combined with a dimmer insert.
A 2-wire extension is connected.
o
Set light to the required brightness.
o
Press extension over entire surface for at least 3 seconds.
For confirmation the lighting switches off briefly and then on again to the saved switch-on
brightness.
i
The saved switch-on brightness is deleted after a power failure.
Setting the operating modes
picture 4: Slide switch
The motion detector has three operating modes that can be set using the slide switch (4)
(picture 4). In the as-delivered state, the centre position is set and locked. The slide switch must
be unlocked before a different operating mode can be set.
picture 5: Locking screw
5/14
32540233
J:0082540233
26.07.2010
Light Management
Automatic switch 180° 1.10 m
