JUMO B70.1170.0, Operating Manual

Page: 77 / 118

5 Commissioning/starting up the device 2011-03-13
16
5.3 Selecting and editing parameters (plausibility inquiry for input values)
In the standard mask, the measured value limit value or the value for the pre-alarm is displayed depending on the configuration.
h
Carry out step 1 ... 4 to edit a value, e.g. limit value AL in this case.
1 Press for more than 2 sec
The first value in the parameter level appears
2 Use to increase the value
or
Use
to decrease the value
AL flashes
3 Briefly press
As a control, limit value AL flashes at the top and
bottom of the display.
4 Briefly press to confirm the
value.
The value is saved.
Use + to return to the standard mask or
return automatically after timeout
H
If in the parameter level no key is pressed for 30 seconds,
the device automatically returns to the standard mask (timeout) and the value is not saved.
v
see operating overview on the first inner page of this manual.