JUMO B70.1170.0, Operating Manual

Page: 111 / 118

14 Error messages
2011-03-13
50
14 Error messages
Error display (Err) Cause Remedy
The limit value for relay alternations is
exceeded.
h
Increase the limit value for the relay alternations.
v
Chapter 7.11 „C 120 Limit value for relay alterna-
tions“
h
Use the Reset key (press >3sec) for acknowl-
edgement.
v
Chapter 7.12 „C 121 Counter reading for relay
alternations“
0002 Terminal temperature
is outside the range -10...80°C
h
Check ambient temperatures
h
Use the Reset key (press >3sec) for acknowl-
edgement.
If the error cannot be remedied, send the device in.
0003 Reference voltage
The measured value either exceeds 999 or
goes below -999 and is outside the 3-digit
display range. - A/D converter error
h
Use the Reset key (press >3sec) to acknowledge
If the error cannot be remedied, send the device in.
0004 Calibration constant The device must be repaired by JUMO.
h
Send in the device.
v
Chapter 2.1 „Service addresses“
0005 Configuration data
Value cannot be displayed (too high or too
low)
0006 reserved -
0007 reserved -