LC4 F
11
protection should be set at least 25 °C below the fire point.
•
Set up the heating device according to the instructions prior to connection to
the controller and ensure secure attachment to the bath.
Danger of burning and fire!
•
Immerse both temperature sensors in the bath medium and ensure secure
attachment.
•
Do not stay in the area below the unit.
•
Make sure you read and understand all instructions and safety precautions
listed in this manual before installing or operating your unit.
•
Check the filling level of the bath fluid from time to time. The heater must
always be fully covered with the bath fluid!
•
Never operate the unit without bath fluid in the bath.
•
Never operate damaged or leaking equipment.
•
Always turn off the unit and disconnect the mains cable from the power
source before performing any service or maintenance procedures, or before
moving the unit.
•
Transport the unit with care.
•
Sudden jolts or drops may cause damage in the interior of the unit.
•
Always empty the bath before moving the unit.
•
Never operate equipment with damaged mains power cables.
•
Observe all warning labels.
•
Never remove warning labels.
•
Always turn off the unit and disconnect the mains cable from the power
source before cleaning the unit.
•
Repairs are to be carried out only by qualified service personnel.
•
Some parts of the bath cover may become extremely warm during
continuous operation. Therefore, exercise particular caution when touching
these parts. Use safety glasses!