Jula Meec tools 015654, Operating Instructions Manual

Page: 36 / 37

EN
36
FIG. 23
FITTING THE EXTENSION ARM, SUPPORT AND
HANDLE
FIG. 24
FIG. 25
FIG. 26
FITTING THE LOCK KNOBS
Fit 2 lock knobs with the screws M8 x 20.
FIG. 27
FITTING THE EMERGENCY STOP
Fit the emergency stop on the motor plate with 4 screws M4 x 55.
FIG. 28
USE
NOTE:
Before using the product it must be secured to the surface
through the four holes in the feet.
FIG. 29
TO CHECK BEFORE USE
Check the following points before use.
– Check that the blade is intact, sharp and does catch on
any parts.
– Check that all blade guards are intact and correctly
mounted, with enough distance to the blade.
– Check that the log cradle automatically returns to the
home position.
– Check that the power cord, plug and power switch are
undamaged. Electrical parts must only be repaired by
an authorised electrician.
– Check that the saw blade stops no more than
10 seconds after the motor is switched off.
HOW TO USE
WARNING!
Risk of personal injury as a result of pieces of wood being
ejected
1. Connect the saw to the mains.
2. Press the power switch marked
I .
3. Start the saw and wait until the motor has reached full
speed.
4. Place a log in the log cradle.
5. Cut the log by moving the log cradle towards the blade.
Keep both hands on the log cradle handle.
– Do not push so hard that the speed of the motor is
reduced.
– Press the log cradle forwards all the way to the stop.
4. Move the log cradle all the way back to the home position.
NOTE:
If the log is not cut off completely, turn it over and saw from the
other side.
5. Remove the sawn piece, feed forward and cut the next.
6. Switch off the saw by pressing the switch marked
0 .
NOTE:
•
Check before sawing that there are no foreign objects such
as nails or screws, in the wood to be cut.
• Crooked logs should be placed in the log cradle with the
curved side towards the saw blade.
• Do not lock down the log to be cut.
• Do not try to brake the blade by pressing the log against
the side of the blade.
• Only use sharp saw blades.
• Never cut bundles of wood or several logs at the same
time. The saw blade can eject pieces that can cause
personal injury.
MAINTENANCE
NOTE:
•
Switch off the product, pull out the plug and wait until all
moving parts have completely stopped before cleaning
and/or maintenance.
• Check that all safety devices function correctly after
maintenance.
• Only use parts and accessories recommended by the
manufacturer, otherwise there is a risk of personal injury
and/or material damage.
CLEANING
Blow clean the saw with compressed air, or extract sawdust with
a dust extractor.
PERIODIC MAINTENANCE
At intervals of 50 working hours:
– Check all screw unions. Retighten if necessary. The log
cradle and log cradle stop should move.
– Check the assembly, wear and sharpness of the blade.
– Remove any deposits on the inside of the saw blade.