－
60
－
No.
Function
Setting range State when delivered
Remarks
U036
Feed timing is selected.
When stitches are not well-tightened, set the value in
“–” direction.
− 8 to 16
12
Setting on exces-
sive “–” side may
cause needle break-
a g e . B e c a r e f u l
when sewing heavy-
weight material.
U037
State of work clamp foot after completion of sewing can be selected.
: Work clamp foot goes up after moving at the sewing start
: Work clamp foot goes up immediately after the end of sewing.
: Work clamp foot goes up by pedal operation after moving
at the sewing start.
-
For LK-1903S/
BR35, set to "
".
U039
Execution of origin retrieval every time after completion of
sewing can be performed.
(Except cycle stitching)
: Without origin retrieval
: With origin retrieval
-
U040
Setting of origin retrieval in cycle stitching can be set.
: Without origin retrieval
: Every time 1 pattern is completed
: Every time 1 cycle is completed
-
U041
State of work clamp foot when machine stopped by temporary
stop command can be selected.
: Work clamp foot goes up.
: Work clamp foot goes up with work clamp foot switch.
: Lift of work clamp foot is prohibited.
-
U042
Needle bar stop position is set.
: UP position
: Upper dead point
-
Needle bar rotates
in the reverse direc-
tion after the UP po-
sition stop and stops
when upper dead
point stop is set.
U046
Thread trimming can be prohibited.
: Normal
: Thread trimming prohibited
-
U048
Route of origin return by means of clear key can be selected.
: Straight line return
: Reverse return of pattern
-
This function is
used when straight
line return from the
midway of pattern
to the start of sew-
ing is not possible.
U049
Bobbin winding speed can be set.
800 to 2000
1600
Max. speed limita-
tion has priority.
U051
Wiper operation method can be selected.
: Without wiper at the time of thread trimming on the way
: With wiper at the time of thread trimming on the way
①
: With wiper at the time of thread trimming on the way
-
①
: Without return
of the last wiper
②
: With return of
the last wiper
