JUKI DDL-9000C Series, Engineer'S Manual

Page: 122 / 198

No. Item Setting range Unit
Initial value
SMS SSH FMS FSH SMS CE SSH CS FMS CE FSH CE
U035 Minimum speed of the pedal
The maximum number of revolutions during thread trimming
differs with the machine head.
150 to Max.
of thread
trimming
sti/min 200 200 200 200 200 200 200 200
U036 Speed during thread trimming
The maximum number of revolutions during thread trimming
differs with the machine head.
150 to Max.
of thread
trimming
sti/min 300 220 300 220 300 220 300 220
U037 Speed during soft start
The maximum number of revolutions during soft start differs with
the machine head.
The number of revolutions set with this memory switch is given
precedence even if it is lower than the lowest speed by pedal.
100 to Max sti/min 800 800 800 800 800 800 800 800
U038 Speed during one-shot stitching
The maximum number of revolutions during soft start differs with
the machine head.
100 to Max sti/min 2500 2500 2500 2500 2500 2500 2500 2500
U039 Start position of rotation 10 to 5000 - 600 600 600 600 600 600 600 600
U040 Start position of acceleration 10 to 1000 - 900 900 900 900 900 900 900 900
U041 Start position of lifting of presser foot − 500 to − 10 - − 100 − 100 − 100 − 100 − 100 − 100 − 100 − 100
U042 Start position of lowering of presser foot 10 to 500 - 300 300 300 300 300 300 300 300
U043 Start position of thread trimming − 1000 to − 100 - − 840 − 840 − 840 − 840 − 840 − 840 − 840 − 840
U044 Position that maximum sewing speed is reached 10 to 15000 - 4000 4000 4000 4000 4000 4000 4000 4000
U045 Pedal neutral-position correction value − 150 to 150 - 0 0 0 0 0 0 0 0
U047 Presser-foot lift finishing position
The position to which the presser foot goes up when the back
part of the pedal is depressed to its first step. (1st-step spring
position)
− 1000 to
− 100
- − 600 − 600 − 600 − 600 − 600 − 600 − 600 − 600
U049 Presser foot lowering time
The initial value differs with the machine head.
0 to 500 ms 100 100 100 100 100 100 100 100
U051 Correction of turning-ON of reverse feed stitching (at start) − 50 to 50 Degree 0 0 0 0 0 0 0 0
– 106 –