− 132 −
Error code
Description of error
How to recover
E489
Combination data other than right/left flap sewing is set at
the time of flap priority setting of alternate sewing mode.
Possible to
re-start after
reset.
E490
It is not possible to feed up to corner knife position.
When flap is put on this side in case of the long type
Possible to
re-start after
reset.
E491
Corner knife length is too short.
When knife cannot be entered since the interval of corner knife is
short.
Possible to
re-start after
reset.
E492
L size length is too short.
When sewing cannot be performed since the inputted L size
length s too short
Possible to
re-start after
reset.
E493
L size length is too long.
When sewing cannot be performed since the inputted L size
length s too long.
Possible to
re-start after
reset.
E494
Center knife length error
When center knife length is smaller than knife size of 6.7 mm
Possible to
re-start after
reset.
E495
Length at sewing start/sewing end over
When sewing length is shorter than the total of length of each
condensaton (back tack) at sewng start and sewng end
Possible to
re-start after
reset.
E496
Condensation at sewing end length over
When condensation pitch X number of stitches exceeds 15.0 mm
Possible to
re-start after
reset.
E497
Back tack at sewing end length over
When back tack pitch X number of stitches exceeds 6.0 mm
Possible to
re-start after
reset.
E498
Condensation at sewing start length over
When condensation pitch X number of stitches exceeds 15.0 mm
Possible to
re-start after
reset.
E499
Back tack at sewing end length over
When back tack pitch X number of stitches exceeds 6.0 mm
Possible to
re-start after
reset.