Judo PROFIMAT JPF-A 1 1/2", Installation And Operating Instructions Manual

Page: 11 / 40

Installation
1701649 • 2019/04 JUDO JPF-A 11
The flange surface of the rotary
flange fitting must be upright!
For proper sealing the profile of
the profile flange seal must point
towards the rotary flange fitting
(see
Figure 4
).
JPF-A ¾" - 2"
Fig. 5: Attach and engage appliance
1 Insert screws
2 Turn clockwise to engage screws
Fig. 6: Connection of appliance
engaged
Do not undo the screws of the device!
1.
Insert the heads of the four flange
screws through the bayonet holes on the
rotary flange fitting (see Figure 5).
2. Turn the device in clockwise direction up
to the stop (see Figure 5 and Figure 6).
3. Tighten the four flange screws.
UNIT
Select the tightening torque (about
4 Nm for the pipe connection range
¾" - 1¼" / about 10 Nm for the pipe
connection range 1½" - 2") so that
the seal is effective and the device is
not damaged or strained!
JPF-A 2½" - 4"
Filters with a nominal size of 2½" or more
should preferably be installed in a horizon-
tal line. When operating in a vertical line,
the coarse particles deposited in the sludge
trap cannot be backwashed out as optimally
as when operating in a horizontal line.
4.4 Draining of the backwash
water
CAUTION
An adequately sized waste water
connection (e.g. floor drain) in
compliance with DIN 1986 must be
provided.
In order to ensure safe drink-
ing water hygiene, a free dis-
charge of the waste water acc. to
DIN EN 1717 must be ensured.
Prior to plugging in the device,
ensure that the wastewater con-
nection is functional.
The drain must be large enough so that all
of the wastewater can be drained simulta-
neously.
If a wastewater connection directly beneath
the filter is not possible, the backwash
water can be drained away via a hose or a
pipe that is connected from the backwash-
ing water valve over a few meters to the
closest wastewater connection. The dimen-
sioning of this pipe must correspond to the
backwashing water valve.