Judo PROFIMAT JPF-A 1 1/2", Installation And Operating Instructions Manual

Page: 5 / 40

Safety
1701649 • 2019/04 JUDO JPF-A 5
2.2.2 Water temperature
The filter is suitable for use in drinking
water up to a maximum water temperature
of 30 °C (86 °F).
2.2.3 Water pressure
JPF-A ¾" - 2½"
CAUTION
The water pressure must not exceed
232 psi / 1600 kPa input pressure.
The device must not be installed if
the mains pressure is above 232 psi /
1600 kPa (even for a short time)!
Nominal pressure PN 16
Operating pressure 22 - 232 psi
(150 - 1600 kPa)
The water pressure must not fall below 22
psi (150 kPa) as otherwise backwashing
can be impaired!
INFO_NO_HEADER
Starting at an operating pressure of
145 psi (1000 kPa), increased wear
can be expected!
JPF-A 3" - 4"
CAUTION
The water pressure must not exceed
150 psi / 1000 kPa input pressure.
The device must not be installed if
the mains pressure is above 150 psi /
1000 kPa (even for a short time)!
Nominal pressure PN 10
Operating pressure 22 - 150 psi
(150 - 1000 kPa)
The water pressure must not fall below 22
psi / 150 kPa as otherwise backwashing
can be impaired!
2.3 Safety instructions
2.3.1 Electrical danger
ELECTRO_NO_HEADER
Risk of electric shock
No electrical wiring or equipment that is
not splash-proof may run or be stored
below the device. Electrical devices/
equipment located in the vicinity of the
device must be splash-proof or comply
with the legal regulations for wet rooms.
Only the supplied power supply unit may
be used to connect the unit to the power
supply. This reduces the mains voltage
for operating the electronics to a harm-
less low voltage of 24 V.
A splash-proof socket is required for
connection to the electrical grid, in
accordance with the legal regulations for
wet rooms.
On “potential-free” designs: Only con-
nect potential-free switching contacts
to the potential-free input. Do not apply
extraneous voltage!
On “potential-free” designs: Only low
voltages can be used for the remote
transmission of the fault indication via
the potential-free output!
The power supply unit must be con-
nected to make the electrical installation
and to adjust the DIP switch.
Switching voltage: maximum 24 V
Amperage: maximum 1 A
2.3.2 Warning of property damage
WARNING
Risk of water damage or damage
to property
The device may only be installed by
qualified technical personnel.