JUDO BIOSTAT-COMBIMAT
17
Operation
5.6
Cleaning/flushing
Depending on the quality of the water and
the operating methods, a thin coating of lime
is formed on the brush in the treatment
chamber. This lime layer must be removed
and flushed out of the water treatment
device at regular intervals.
The water treatment device has a unit to
clean the brush and a flush valve for rinsing
out the lime particles.
Cleaning and flushing is carried out auto-
matically by two electric motors.
During a cleaning/flushing cycle, the yellow
LED 2 lights up.
Cleaning/flushing can be started manually
by operating the manual push button.
5.7
Warning message “Battery flat”
To ensure that a cleaning/flushing cycle is
carried out completely, even in case of a
power failure, the water treatment appliance
has a 9 V block battery installed as an emer-
gency power supply.
Before each cleaning/flushing cycle a
battery test will be carried out. A missing,
unloaded or defective battery is indicated by
the flashing of the red LED 3. No cleaning
cycle is then possible.
5.8
Mounting the cover caps
Dismantling:
–
Disconnect the power supply from the
socket.
–
Withdraw the upper/lower clamping
fixture.
–
Carefully pull apart the right and the left
panel parts by the handle cavities on the
back of the cover.
–
Remove the type plate and the cover.
Assembly:
–
Push the right and left parts of the covers
together till a gap of approximately
15 mm is left.
–
Ensure that the cable is not trapped!
–
Refit the type plate in the blanks, of the
covers, situated above and below.
–
Push the covers completely together.
–
Plug the power supply into the socket!
Make sure that the drain connec-
tion is functional before plugging
the power supply into the socket
(see chapter “Discharging the
flushing water”).
