JUDO BIOSTAT-COMBIMAT
11
Installation
The profile of the profiled flange gasket must
face towards the built-in rotary flange
fig. 7). Failure to observe this can lead to
leaks and water escaping. This can cause
damage due to water to the house and
installations.
4.2.6 Mounting the bypass valve
(accessories)
When assembling a bypass valve between
the built-in rotary flange and the water treat-
ment device an additional bypass piping be-
comes superfluous to requirements.
–
Firstly flush the water pipe with the newly
installed rotary flange (JQE) and block
off the water again (at the main water tap
or blocking valve).
–
Remove the assembly cover of the
built-in rotary flange.
–
Connect the bypass valve on the flange
side with the cast in letter “R” (pipe
flange) to the built-in rotary flange by
engaging the bayonet fitting (see fig. 8).
–
Tightly fasten the four cylinder screws
M6x25.
The hand-wheel of the bypass valve can be
positioned anywhere above the unit or to the
side. Depending on conditions on site,
installation should be carried out ensuring
sufficient access to the hand-wheel.
4.2.7 Mounting the water treatment
device to the pre-assembled
bypass valve
–
Remove the white protector cap on the
connecting flange of the water treatment
device by unscrewing the four M6 Allen
screws.
Do not completely unscrew the screws
because of the bayonet connection!
–
Lift up the water treatment device and
swivel it approx. 30° in an anti-clockwise
direction.
–
Position it on the flange of the bypass
valve so that the screw heads pass
through the bayonet fixing drill holes.
(see fig. 6 I).
–
Swivel the water treatment device approx.
30° back in a clockwise direction and
tighten the four Allen screws (see fig. 6 II).
Fig. 7: Built-in rotary flange
Select the torque (approx. 4 Nm) so
that the gasket closes!
profiled flange gasket
Fig. 8: Bypass valve with bayonet fixing
Select the torque (approx. 4 Nm) so
that the gasket closes and the water
treatment device is not damaged or
strained!
pipe flange (“R”)
unit flange (“G”)
built-in rotary flange
hand-wheel
