5-61
5.5.1. Connecting the Power cable connector
The connector manufacturer (Nanaboshi Electric MFG Co., Ltd.) recommends the following
method of cable connection.
(1) Disassemble the connector, as shown here.
(a) Remove the insert assembly from the end bell by turning the assembly counterclockwise.
(b) Loosen the clamping nut to remove the cable packing.
(2) Pass the cable through the disassembled parts in the sequence shown here.
Note:
Be sure that all the parts are placed in the specified sequence and in the
correct direction.
(3) Peel the cable sheath and wires according to the dimensions specified here.
(4) Process the ends of the cable's core wires and pretin them.
Note: Do not pretin the cable sheath.
Note: When the cable core is pretinned, it should be uniform everywhere and smaller
than the diameter of the opening in the contact.
Clamping nut
Cable pakkin
End bell
Insert assembly
Clamping nut Cable pakkin
End bell
Cable
Solder
Contact
Iron tip
Cable
Core
wire
Cable
Core wire
Sheath
18mm
7mm
Conductor cross-sectional area
2 mm
2
Cable outside diameter
7.0 to 8.5 mm
Summary of Contents for NT337-XL2
