5-62
(5) Soldering
(a) Insert the pretinned core wires into the contact's solder pot.
(b) Using a soldering iron, heat the contact and the core wires.
(c) Let solder flow into the gap between the contact and the core wires until the gap is filled.
(6) Assemble the connector.
(a) Clamp the insert assembly and tighten the end bell with the specified torque.
(b) Push the cable packing into the end bell, clamp the end bell, and tighten the clamping nut
with the specified torque.
(c) Move the cable back and forth until it moves easily (as shown). Once again, tighten the parts
with the specified torque.
Soldering iron
wattage
[W]
Conductor
cross-sectional area
[mm2]
Iron tip
temperature
[
℃
]
30
2
350 to 370
Where to tighten
Shell size: 20
End bell
1.0 to 1.5
Clamping nut
1.5 to 2.0
[Unit: N-m]
Clamping nut Cable pakkin
End bell
Insert assembly
Summary of Contents for NT337-XL2
