JRC JSS-2150 -, Instruction Manual

Page: 126 / 248

Operation
4-60
Message Buttons Description
Error
File access failed.
OK
The specified file cannot be used for
any malfunction.
Error
Invalid file.
OK The file is malformed and invalid.
Error
Keyboard I/F ROM checksum error.
OK
Detected the keyboard I/F ROM
checksum error.
Error
No folder exists.
OK A specified folder is not found.
Error
No response.
OK
The controller may be busy and
returns no reply to the data terminal.
Error
Overcurrent has been detected at the USB
port.
OK
The attached USB device may be
failure.
Error
Register the 9-digit Self-ID in advance.
OK
Own station ID (9digit selcal number)
is needed to call the station by the 9
digit selcal number.
Error
Register this station's ID in advance.
OK
Own station ID is needed to call the
station in the telex mode.
Error
The antenna is not tuned correctly.
Tune to the frequency now?
Yes/ No
The antenna is not tuned. Starts the
antenna tuning immediately?
Yes: Tunes
immediately.
No: Tuning is not needed.
Error
The attached USB device is not supported.
The DTE supports the USB memory only.
OK
The data terminal detects the USB
device except the USB memory.
Error
The DTE failed to access to the file system.
OK
The file system and the files are
inaccessible now.
Error
The DTE failed to print.
OK
Printing is unavailable now.
Error
The DTE failed to stop the USB drive.
OK The USB drive cannot be unmounted.
Error
The DTE was unable to complete the
format. Please remove the USB memory.
OK
The data terminal failed to format the
USB memory, so remove the USB
memory.
Error
The file is too large.
OK
The specified file cannot be opened
because of the file size beyond the
8kB.