JRC JLR-21, Instruction Manual

Page: 75 / 164

5-11
5.2.9 Anchor Watch Settings
●
Starting the anchor watch
Press and hold the key for 2 seconds to set (start) anchor watch.
1. Select ANCHOR using the key, and input a desired range (radius) to watch using the
keys.
2. The range can be from 0.01 to 9.99. The unit of range is the unit configured in SPEED UNIT in the
System menu. Refer to 5.3.6 System settings for details.
3. Next, enter the input range (radius) using the key.
4. Select START and press the key to start anchor watch.
During anchor watch, the following icons are displayed in a status bar (the bar in the bottom of the
screen.)
: Inside the set range (radius)
: Outside the set range (radius)
●
Stopping the anchor watch
1. Stop the anchor watch by pressing and holding the key for 2 seconds again.
2. The following pop-up is displayed, then, select STOP using the key.
At a confirmation display- “STOP ANCHOR WATCH. ARE YOU SURE?”, select YES to stop
anchor watch.
Selecting YES stops anchor watch.
Selecting YES stops anchor watch.