JR Vibe 90SG, Assembly Instructions Manual

Page: 35 / 106

35
Flat Washer, 3mm (4pcs)
Socket Head Bolt, 3 x 40mm (4pcs)
Nylon Lock Nut, 3mm (4pcs)
270mm
Drive Shaft Collar (2pcs)
Setscrew, 3 x 6mm (2pcs)
Tail Drive Shaft
n
e
e
r
G
)
2
x
(
It is very important that the guide
bearing be attached to the shaft off
center as shown to prevent resonance,
vibration and fatigue.
5-1 TAI L D R I VE S H A FT ASSEMBLY
5-2 TAIL BOOM INSTALLATION
Setscrew, 3 x 6mm (2pcs)
Socket Head Bolt, 3 x 40mm (4pcs)
Nylon Lock Nut, 3mm (4pcs)
Flat Washer, 3mm (4pcs)
Tail Boom
Tail Boom Holder
Shaft Drive Guide (2pcs)
Bearing,
8 x 14 x 4mm (2pcs)
Oil
Apply oil to the inside of the Tail Boom,
then install the Shaft Drive Guide.
Attach the bearing first.
n
e
e
r
G
(x2)
250mm
Do not apply threadlock to the inside
of the ball bearings.
Button Head Bolt,
3 x 4mm (4pcs)
Drive Shaft Insert (2pcs)
Drive Shaft Pin (2pcs)
Button Head Bolt, 3 x 4mm (4pcs)
Drive Shaft Collar (2pcs)
Drive Shaft Pin (2pcs)
)4
x(
d
e
R
Red
(x2)
Note : Install tail boom pipe first,
then slide drive shaft into place
second. Ensure torque tube
engagement into the tail drive
transmission output.
Note : Do not over-tighten
M3x40mm bolts and tail
boom clamps. The gap of the
boom clamp holder and tail
transmission case do not need to
be fully “closed” when tightening
these bolts.