26
Socket Head Bolt, 3 x 25mm (2pcs)
Flat Washer, 3mm (2pcs)
Mount Block Spacer (T96)
3-3
E NG I NE INST A LL A T I ON
Flat Washer, 3mm (2pcs)
Flat Washer, 4mm (4pcs)
Socket Head Bolt, 4 x 20mm (4pcs)
Socket Head Bolt, 3 x 25mm (2pcs)
Socket Head Bolt, 4 x 20mm (4pcs)
Flat Washer, 4mm (4pcs)
Engine Mount Spacer (2pcs)
d
e
R
)
2
x(
After installing the engine assembly to the frames, to set the
proper gear mesh, insert one thickness of paper (the same
thickness as the pages of this manual) between the pinion gear
and main drive gear. Push the pinion bearing block until there
is no gear backlash with the paper in place, and then tighten
the bearing block screws. Then remove the paper and note that
there should be a very slight amount of backlash in the gears.
The mesh plates and preset engine alignment will allow only very
small movement of the pinion gear and make setting this mesh
relatively easy. Repeat this procedure for setting the tail drive
gear mesh.
Check the bottom of the clutch is flush with the bottom
of the clutch bell when fully assembled. If needed, a small
amount of up/down adjustment can be made with the 4x
engine bolts and slop in the engine lug holes. Re-tighten
the engine once set.
Fully tighten all bolts in Steps 2-4 and 2-5 at this time
and follow the gear meshing procedure.
Summary of Contents for Vibe 90SG
Page 77: ...77 ...
Page 105: ...105 ...
