5
GF 160 DV IPI 12/17
STOP! FOR EASIEST ACCESS, INSTALL
FUEL CONVERSION AND FIREBOX
PANELS BEFORE REMOVING THE
STOVE FROM THE PALLET.
2. Initial Assembly
CAUTION: Enamel parts may be damaged if
handled without care. The stove is heavy.
DO NOT DRAG THE STOVE LEGS.
Have assistance available to move the stove into
position. Place removed parts on a blanket, towel, or
other protective material.
Unpacking the Stove
EXCEPT AS NOTED, ALL INSTRUCTIONS ARE ORIENTED
FACING THE FRONT OF THE STOVE.
1. WHITE ENAMEL STOVE ONLY:
• Lift the top plate from the stove.
• Remove and discard the door-stop bolt from the
hinge bar as shown in fig. 2.1.
2. Open the Firebox
• The front door swings open to the left. Grasp it from
the right side or lower edge.
• Lift the Top Plate Grills and Top Plate from the stove
and set aside.
• Remove the Latch Tool from the shipping pallet and
use it to remove the Glass Panel by pulling the two
latch hooks out to disengage them from the glass
frame. Fig. 2.2.
• Tilt the glass frame forward, then lift it straight up
and off of the stove.
3.
Remove the Miscellaneous Hardware kit
from the
firebox and inspect the contents. Refer to the list on
the previous page and contact your dealer if any items
are missing.
4. Install Backup Batteries:
Four AA batteries are supplied
in the Miscellaneous Kit. The battery box is located
in the left side of the controls compartment. Orient
battery polarity ( + - ) as designated on the box label.
See also fig. 16.4, page 33.
Remote Transmitter:
Install 3 AAA batteries supplied
into the hand-held transmitter unit. The transmitter
and appliance have been synchronized at the factory.
5, Optional Equipment and Burner Media
: See Sections 11
and 12 for specific installation instructions.
RE-INSTALL THE TOP PLATE BEFORE
CONNECTING VENT PIPE TO THE STOVE.
Figure 2.2
Disengage the glass frame latches to open the firebox.
Figure 2.1 White Enamel stoves:
Use a 10mm wrench to remove the door-stop bolt.
