34
139894 GF 160 DV IPI 12/17
Remote Transmitter Battery Replacement
The life-span of hand-held transmitter batteries depends
upon battery quality, the frequency of set point changes,
frequency of ignition call changes, etc.
When battery power is low, a Battery icon will appear on
the transmitter display before all power is lost. See fig.
15.18, page 30. The icon will disappear with installation of
three, fresh AAA batteries.
NOTE: Avoid inadvertently pressing the thermostat
function key when replacing the batteries. Doing so
will turn off thermostatic functions. To restore that
function, re-install the batteries while again pressing the
thermostat key.
Receiver Battery Replacement
A red LED on the IFC board indicates low battery power.
1. Set Mode switch to OFF and disconnect AC power to the
stove.
2. The battery box is integrated with the switch housing.
See fig. 16.4. Depress the center release tab to open
the battery access cover.
3. Install four, 1.5v AA batteries following the polarity
orientation shown below and on the panel.
4. Reconnect power to the stove.
Figure 16.6. Receiver battery replacement.
Side Safety Screen Replacement Kit 158063
Read through these instructions before beginning the
procedure.
Tool List:
• 13mm socket
• 24-in socket extension / small ratchet wrench
• #4 hex key
The side screens are secured to the side plates by a steel
bracket, #5, fig. 17.2, page 36, which must first be loosened
to remove the screen frame.
1. Remove the Top Plate
2. Remove the M6 bolt, #11, from the upper bracket strap
at the top of the firebox. Fig. 16.2.
3. Tilt the Side Plate away from the firebox enough to re-
move only the two
upper
button head screws, #6, from
the Screen Bracket, fig. 16.5. There is no need to remove
the lower screws.
4. Tilt the screen bracket back enough to lift the screen
frame up and out.
5. Reverse the procedure to re-install the new screen.
Figure 16.5.
Remove the two
upper button head
screws only.
