EG0LD-1000 Electronic Grease Level Detector
Installation and Operating Procedures
__________________________________________________________________________________________
Page 9
EGOLD-1000 System
3.0 EGOLD-1000 Controls and Indicators
3.1 Control Unit
The face of Control Unit has two (2) momentary push button controls:
Calibrate
Button
-This button is pressed to initiate a calibration procedure.
Alarm Reset
Button -This button is pressed to turn off the level alarm buzzer.
The face of the Control Unit has the following LED indicators:
Power
LED
-When ON this LED indicates that the Control Unit has power applied.
Operating
LED
-When ON this LED indicates that the EGOLD-1000 Electronic Grease Level
Detector system is operating properly in the grease level detection mode.
Calibration
LED
-When ON this LED indicates that the EGOLD-1000 Electronic Grease Level
Detector system is in the grease level calibration mode.
Level
LEDs
-A set of 5 vertical LED indicators displays the current level of grease being
detected in the interceptor tank. Each LED indicator represents approximately
one fifth (1/5) of the maximum grease level volume.
-The bottom three (3)
Green
LEDs indicate the grease volume is below the
level required for grease interceptor tank cleaning. Note: The three (3)
Green
LED indicators are also used during the system calibration.
-The
Yellow
LED indicates the grease volume is approaching the level
required for cleaning the grease interceptor tank.
-The
Red
LED indicates the grease volume has reached the level requiring the
grease interceptor tank to be cleaned.
Figure 3-1 illustrates the face of the Control Unit.
