EG0LD-1000 Electronic Grease Level Detector
Installation and Operating Procedures
__________________________________________________________________________________________
Page 18
Appendix III
Optional Modem Unit
Optional Modem Unit Installation
The following items are provided with EGOLD1000 installation kit when the Optional Modem Unit
is provided:
An external Modem Unit including installation and operating procedures.
A U.L. approved wall mount low voltage power module.
A cable to interconnect the Modem Unit to the wall mounted Control Unit.
A telephone cable to connect the Modem unit to the telephone line.
Install the Modem Unit as follows:
1)
Find a location that is within 15 feet of the Control Unit, within 5 feet of an 115VAC wall
outlet and within 5 feet of a telephone jack to place the Modem Unit provided.
2)
Plug the jack connector of the modem cable provided into the Control unit and the “D”
connector of the modem cable into the rear of the Modem Unit.
3)
Plug the telephone cable into the “line” connector on the rear of the Modem Unit and the
telephone jack.
4)
Plug the power module provided into the wall and plug the power module cord into the
Modem Unit.
5)
Turn the Modem Unit ON as indicated in the operating procedures provided.
6)
Cycle the power to the Control Unit. The “RX” and “TX” indicators on the Modem Unit
should flicker. Note: This indicates the Control unit is communicating to the Modem Unit.
7)
Contact JOSAM when the installation is complete. JOSAM will perform a test of the remote
grease level monitoring function.
