EN
FR ES
!
WARNING
The rear stand-on platform and the rear bench seat are designed for a child that is at least 2½ years old but LESS
than 44 inches (111.76 cm) tall and less than 45 lbs. (20.5 kg).
Use of the stroller with 3 children totaling more than 125 lbs. (56.8 kg) will cause excessive wear and stress on the
stroller and may cause a hazardous unstable condition.
NEVER allow a standing child to use the canopy as a hand hold.
NEVER use this stroller to carry more than 3 children at the same time.
13 Using the Rear Bench Seat
• Push the bench seat to its most rearward position.
NOTE:
There are webbing straps attached to the bottom of the rear seat pad. These straps will lock the seat into the most rearward
position. To lock the seat, pull the straps from EACH side of the pad and loop them around the frame as shown, then snap them together.
See Figure 13.1
.
• To slide the seat forward, undo EACH snap and reattach the webbing to the underside of the seat pad using the Velcro® attachments.
• Position the canopy to its most forward position.
• To unlatch the buckle press the center button and remove both latch posts.
• Have the child sit on the bench seat facing backward with their feet on the platform.
• You may need to adjust the recline position of the front seat to allow for more room for the child to sit.
• Place the crotch strap between the child’s legs.
• Push the waist latch posts into the crotch buckle until all parts snap into place.
See Figure 13.2
.
• Adjust the waist straps to be snug around the child’s waist.
• Be sure that BOTH of the child’s feet are fully on the platform at all times.
• Be sure that BOTH of the child’s hands are holding the frame.
!
WARNING
NEVER allow a rear seated child to use the canopy as a hand hold.
14 Storage Basket
The maximum weight that can be carried in the storage basket is 10 lbs. (4.5 kg).
15 Folding the Stroller
• Keep children away from stroller while folding.
• Remove any infant car seat. The stroller can be folded with the infant car seat adapter in place.
• Close BOTH canopies and push it forward.
• Put the front seats into there most upright position.
• Make sure both rear wheel brakes are set to their locked positions.
• Lock BOTH front wheel sets in place with locking levers facing forward.
• Unlock the safety latches on the BOTH sides of the stroller.
• Pull upward on the trigger mechanisms on both sides of the stroller and push the handle fully forward.
See Figure 15.1.
CAUTION: While folding the stroller, be careful to keep your fingers from being pinched by moving parts.
• Engage the fold lock on the right side of the stroller over the mounting post.
See Figure 15.2.
!
WARNING
ALWAYS keep children away from the stroller when folding.
Possible pinching hazard – Be careful when folding the stroller.
16 Using the Stroller with Infant Car Seats (OPTIONAL)
These steps are for BOTH front facing seats. The Big Caboose Graphite will accommodate a car seat in EACH of the front seats.
NOTE: See insert for a list of specific compatible car seat models.
• Remove the front tray and the front canopy. Install the infant car seat adapter in the front tray mounts. Ensure it is secure on BOTH sides.
See Figure 16.1.
• ADJUST THE SEAT TO ITS RECLINE POSITION.
• Remove the infant car seat from its base and place it onto the front seat of the stroller so it is in a REAR FACING POSITION. Position the
“head” end toward the front, resting on the infant car seat adapter. Position the “feet” end on the seatback - but NOT on the top edge of
the seatback.
See Figure 16.2.
• Buckle the restraining straps over the LOWEST part of the infant car seat (the straps are located in the pockets on the side of the seat).
Adjust the straps so they are tight around the infant car seat but AWAY from the child’s neck. Pull up on the infant car seat to be sure it is
secure.
See Figure 16.3.
• To remove the infant car seat from the stroller, unlock the restraining strap buckle by pressing the button and both side releases.
See
Figure 16.4.
• Return the restraining straps to their pockets.
