FlexSys
Thermostat Zone Controller / LCD Touch Screen
TEC - 3620
Model:
©2016 Johnson Controls | The performance specifications are nominal and conform to acceptable industry standards. For applications at conditions beyond these specifications, consult the local
Johnson Controls office. Johnson Controls, Inc. shall not be liable for damages resulting from misapplication or misuse of its products.
© 2016 AirFixture, LLC
2
Installation / Operation Manual
V160919
TEC3000 Series On/Off or Floating Fan Coil and Zoning Thermostat Controllers with Dehumidification
Capability Installation Instructions
North American Emissions Compliance
United States
Canada
Installation
Parts Included
•
one TEC3000 Series Thermostat Controller with
integral mounting base
•
one installation instructions sheet
Location Considerations
Locate the TEC3000 Series Thermostat Controller:
•
on a partitioning wall, approximately 5 ft (1.5 m)
above the floor in a location of average
temperature
•
away from direct sunlight, radiant heat, outside
walls, outside doors, air discharge grills, stairwells,
and from behind doors
•
away from steam or water pipes, warm air stacks,
unconditioned areas (not heated or cooled), or
sources of electrical interference
For integrated passive infrared (PIR) models, be sure
that the thermostat controlle
r is located centrally, where
occupant movement is frequent.
Note:
Allow for vertical air circulation to the
TEC3000 Series Thermostat Co
ntroller. Also allow for
sufficient clearance to insert a USB drive into the USB
port.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment
and receiver.
•
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
This Class (B) digital apparatus meets all the
requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la Classe (B) respecte
toutes les exigences du Règlement sur le matériel
brouilleur du Canada.
IMPORTANT:
Only connect memory devices to the
USB port. Do not use it for charging external
devices.
Figure 1: Thermostat Controller
Shown with Occupancy Sensor,
Dimensions, in. (mm)
F
IG
:t
h
er
m
o
st
a
t
fe
a
tu
re
s
USB Port
Display
Cover Screw
1-13/32
(36)
Occupancy
Sensor
4-23/32
(120)
5-5/8
(143)