Cruisecontrol GC55 Installation manual
11
3.4
Electric servo
The servo can be installed in both engine bay to the body, and underneath
the dashboard. Never mount the servo to the engine.
Mount the servo at least 30cm from sources of electrical interference and
heat sources.
Before the servo can be installed, it has to be assembled first.
3.4.1
Assembly electric servo
Step
Action
Picture
1
Remove the red protection cap from the servo cam
2
Mount the appropriate pulley to the servo
The different travels are marked on the
pulleys. The visible text indicates the
applicable travel.
Red pulley = 31-38mm
Yellow pulley = 18-24mm
3
Secure the pulley with the M6 locking nut
4
Remove the servo inner cable
5
Shorten the servo outer cable if necessary by cutting it with sharp pliers on the
servo side of the cable
6
Place the outer cable in the ‘slope’
The colour of the pulley has to match
the colour of the dot on the slope. Also
check the printed travel on the slope,
this has to match the travel printed on
the pulley
7
Guide the servo inner cable through the outer cable and fit the end clamp into
the gap of the pulley
8
Fit the slope with the servo cable to the servo
9
Check that the servo cable runs between the edges of the pulley
10
Slide the cover over the servo and secure it with the 2 screws. Insert the long
screw on the outside edge. Fit the spring washer to the short screw
