Cruisecontrol GC55 Installation manual
14
3.5.1
Adjusting servo cable travel
Possible travel for the cable linkage (see pictures § 3.5.1) depending on the
chosen pulley: red pulley = 31-38mm – yellow pulley = 18-24mm.
The actual travel of the servo, travel X, is
visibly printed on the pulley. Travel A, the
travel of the connection to the throttle,
has to be equal to or 2-3 mm longer than
the travel of the chosen pulley.
In case travel A is longer than travel X
+3mm, adjust the cable linkage as
displayed.
Alternatively apply a pulley with a longer
travel § 3.4.1 (if applicable).
In case travel A is shorter than travel X,
adjust the cable linkage as displayed.
Alternatively apply a pulley with a shorter
travel § 3.4.1 (if applicable).
Always check for a smooth operation of the throttle valve, throttle cable
and servo cable by operating the throttle by hand and by foot.
Make sure that they cannot jam in any way.
First learn the GC55 to the speed signal, before using the cruisecontrol. Refer to chapter
4.0 Set-up.
