Cruisecontrol GC55 Installation manual
15
4
Set-up
4.1
Introduction set-up
These symbols are used for the command module:
i
action
Zeichen
function
up
SET /ACC
down
RES/DEC
push
ON/OFF
pull
CANCEL
First learn the GC55 to the speed signal, before using the Cruisecontrol:
refer to § 4.3 Vehicle speed signal set-up.
Check during the test drive (§ 4.3) the response time and sensitivity of the cruise control.
Only adjust the response time if the Cruisecontrol engages too slowly or too
aggressively:
refer to § 4.4 Increase response time;
refer to § 4.5 Reduce response time.
Only adjust the sensitivity if the Cruisecontrol reacts too forcefully or too slowly while
cruising:
refer to § 4.6 Increase sensitivity;
refer to § 4.7 Reduce sensitivity.
