78
Installation Instructions
iii-4
smartSpeed
1
1Ph - SmartSpeed
(INVERTER)
230 V, 1Ph, 50/60Hz, 17A
200 V, 1Ph, 50/60Hz, 20A (Japan)
Standard models
iii Installation procedures
Electric connection
CAUTION
: ANY INTERVENTION ON THE ELECTRI-
CAL SYSTEM AND THE CONNECTION OF A PLUG
(WHEN NECESSARY), MUST BE PERFORMED
ONLY BY A QUALIFIED ELECTRICIAN, IN COMPLI-
ANCE WITH THE APPLICABLE STANDARDS AND
NATIONAL LAWS AND/OR LOCAL REGULATIONS.
The standard models of the tyre changers have
electrical specifications and are supplied according to
the different power supplies that they will be connected
to. See tables on the side.
The electric motors operate with a voltage tolerance
equal to more or less 10%.
The power supply cable, which is always supplied with
the machine, must be fitted with an adequately sized
type-approved plug, in compliance with the applicable
standards in the destination country.
For the installation technician
The qualified electrician, when fitting a plug, must refer
to the data clearly indicated on the plate found on the
machine electrical cable.
The user must ensure that the electrical system that the
machine is connected to, is fitted with
20 A
fuses (
25
A
for Japan) or alternatively, an equivalent automatic
magneto-thermal switch.
Check that there is an efficient earthing system.
After the connection, press down the wheel support
rotation control pedal (
1, Fig. iii-4
) and check that it
rotates clockwise.
Check that the power supply system is fitted with an
automatic cut off device against overcurrents, with a
differential switch calibrated to 30 mA.
WARNING
: ONLY USE TYPE
B
CIRCUIT BREAKERS.
