JMQ E6, User Manual

Page: 26 / 29

26
Rowing pull rod cord diagram
Figure 15
1. Thread the rowing rod (#80) (2770mm) without the ball head end through and attach the pulley
(#19) in sequence as shown; attach the end to the front bottom frame (#2) with 1 hex head bolt
M10x25 (#65), 2 flat pads
Φ10 (#56) and 1 lock nut M10 (#75);
2. Attach the rowing rod (#23) and rowing rod pull cord (#80) (2,770mm) ball head end together
using 2 snap rings (#76) and a chain (#77) (280mm).
Note: The tension of the draw cord can be adjusted by adjusting the locking hole position of the
pulley (#19) on the adjusting plate (#24), or by adjusting the length of the chain (#120) (490mm).
Installation steps