JMQ E6, User Manual, Page: 14 / 29

14
(#124), 4 flat washers Φ10 (#56), 2 locknut M10 (#75) and 1 hex head bolt M10x95 (#127), 2
curved washers Φ10 (#85) and 1 locknut M10 (#75).
3. Insert a single rod bend (#122) at the upper end of the right column (#92) into the rear top beam
(#89) connection with 2 hex head bolts M10x110 (#72), 4 curved pad
Φ10 (#85) and 2 lock nuts
M10 (#75) to connect the welded plate 8 (#126), rear top beam (#89) and right column (#92);
4. Lock all bolts.
Installation steps
Figure 5
1. Install the Φ60 plastic pipe plug (#97) on the right side of the push arm (#11) as shown; then
place the foam Ø53 × Ø90 × 245 (#35) on the right side of the push arm (#11).
2. Insert a shaft-mounted Ø19 bushing (#42) on the upper right (#11) of the push arm into the
winged rack (#7) as shown; lock with a flat pad Ø12 (#121) and a locknut M12 (#112); (left