SECTION 7 - ACCESSORIES
3121734
7-13
Safety Precautions
DO NOT OVER LOAD PLATFORM.
DE RATE THE PLATFORM BY 70LBS/32KG WHEN PLASMA CUTTER IS IN THE PLAT-
FORM
• Check for cracked welds and damage to plasma supports.
• Check for proper and secure installation of welder and
bracket.
• Make sure no personnel are beneath platform.
• Do not exit platform over rails or stand on rails.
• Only use this option on models specified.
• Keep lanyard attached at all times.
• Ground connect is made.
• Use proper cutting apparel.
• Use correct cutting settings.
• Do not use electrical cords without ground.
• Do not use electrical tools in water.
• Do not cut platform.
• Do not ground through the platform.
• Wear proper cutting apparel.
• Do not drive machine while connecting external air/gas
sources.
• Preparation and Inspection
• Connect ground clamp to metal being cut, make sure
there is a good ground connection, begin cutting.
Operation
Use output control to set cutting output.
Place control in gas/air set position to safely adjust gas/air pres-
sure. Only gas/air circuit is activated.
If 22-27 amperes of cutting output is used with 115 VAC input
power, and overload protection on the input power circuit fre-
quently opens, either reduce the cutting output and/or the cut
time or find more adequate power.
To
order
go
to
Discount-Equipment.com
