PAGE
85
of
131
CX0098 Rev 07.5
3.
Flip the yoke 180° and reverse the probe holder arms
(Fig. 206)
.
4.
Place the pivot buttons on the inside of the probe holder arms
(Fig. 207)
using a 3/8 in wrench
(Fig. 2)
. Slide the arms onto the yoke and tighten the
probe holder arm adjustment knob and the arm clamp screw.
5.
Loosen the swing arm knob and slide the swing arm to the opposite end
of the probe holder bracket
(Fig. 208)
or preferred position. Tighten swing
arm knob.
6.
Using the 3 mm hex driver, screw the yoke pivot screw into the opposite
side of the probe holder swing arm
(Fig. 209)
. Ensure the yoke is level to
avoid issues with the plunger/set screw.
Fig. 208
-
Position swing arm
Fig. 209
-
Install yoke to swing arm
Fig. 210
-
Reversed probe holder