Do Žlábku 733, 514 01 Jilemnice
Subject:
MTP Technical documentation
Page No./No. of pages:
15/20
T1 - safety
- switches the burner off by disconnecting its supply voltage and it is blocked
in its off state. To enable a new automatic start of the burner, it is necessary
to press the button on the triple thermostat. Between the moment of the
burner blocking and the unblocking of the triple thermostat, the temperature
must drop below the value set on the thermostat T1. The condition for restart
of the heater is removing the cause of overheating.
The electronic thermostat used allows remote resetting of the safety
thermostat T1 (e.g. by a button located on the door of the control cabinet),
which is advantageous for heat exchanger units located in poorly accessible
places (e.g. suspended from the ceiling).
In the event of a power supply failure (during burner operation), due to the
accumulated heat in the heat exchanger chamber and the fan malfunction,
the temperature will increase. If the temperature exceeds the value set on
the safety thermostat T1, this thermostat will disconnect the burner supply.
The electronic thermostat resets itself when the network is switched on again
if the temperature has already dropped below the set value (for a long-term
power outage). For a short-term power outage, it is necessary to wait for the
fan to cool the chamber and to reset it by pressing the button on the
thermostat.
T2 - operational
- switches off the burner when the set temperature is exceeded and switches
it on again when the temperature drops
T3 - fan
- switches the fan on after reaching the set temperature, ensures fan
slowdown and cooling the chamber after switching off the burner.
Important information
The main switch can only be switched off after the fan has been completely
stopped. For longer shutdowns, it is necessary to close the fuel supply.
After professional commissioning, the set device parameters cannot be further changed to
ensure trouble-free operation.
In order to increase safety, we recommend the operator to inspect this heating system at
least once a year by a supplier worker or a service worker!
The heater can only be operated by persons over the age of 18.
The heater can only be operated by persons physically and mentally competent for this
activity.
