background image

2014

3

SFP3-14-GB

www.jilong.com

13. Attention: Always keep the product at least 2m away from the pool.

14. Attention: Always keep the plug at least 3.5m away from the pool.

15.Warning: Never start the product while the pool is in use.

16.Warning: Adult assembly and operation are required.

17.Warning: This product is designed for use with movable pools only. It 

must not be used with permanently installed pools. A movable pool is a 

device that can be easily assembled & disassembled for water storage.

18.Warning: To prevent the product from any damage, please turn it off 

before turning the control valve.

19.Warning: To reduce the risk of being sucked into ot towards the pump 

never enter the water when the filter hood is loose, damaged, destroyed 

or lost. Please replace the filter hood immediately if any of the above 

situations pertain.

20.Warning: Do not play or swim near the filter hood. Your body or 

hair may be caught in the pump which can lead to permanent injury or 

drowning.

21.Warning: Do not start the product when the data displayed on the 

manometer on its body exceeds the maximum value specified.

22. Warning:The maximum total head, 1.5 in metres (for pumps having a 

rated power input exceeding 50 W)

23. Warning:The pump is to be supplied by an isolating transformer or 

supplied through a residual current device (RCD) having a rated residual 

operating current not exceeding 30 mA.

24. Warning:The supply cord cannot be replaced. If the cord is damaged 

the appliance should be scrapped.

25. Warning:This appliance can be used by children aged from 8 years 

and above and persons with reduced physical, sensory or mental 

capabilities or lack of experience and knowledge if they have been given 

supervision or instruction concerning use of the appliance in a safe way 

and understand the hazards involved. Children shall not play with the 

appliance. Cleaning and user maintenance shall not be made by children 

without supervision.

26. Attention: The product is intended for use for those purposes detailed 

in the manual only.

This marking indicates that this product should not be disposed 

with other household wastes throughout the EU. To prevent 

possible harm to the environment or human health from 

uncontrolled waste disposal, recycle it responsibly to promote 

the sustainable reuse of material resources. To return your 

used device, please use the return and collection systems or contact the 

retailer where the product was purchased. They can take this product for 

environmental safe recycling.

WEEE

Correct Disposal of this product

Summary of Contents for JL29P423NG













Reviews: