24
Change Settings
Use this item to select an optimal setting for super IO device. Changing setting
may conflict with system resources.
Serial Port FIF0 Mode
The optional settings are: [16-Byte FIF0]; [32-Byte FIF0]; [64-Byte FIF0]; [128-Byte
FIF0].
WatchDog Reset Timer
Use this item to enable or disable WDT reset function. When set as [Enabled], the
following sub-items shall appear:
WatchDog Reset Timer Value
User can set a value in the range of [4] to [255].
WatchDog Reset Timer Unit
The optional settings are: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item support Emulate AT power function, MB power On/Off control by power
supply. Use needs to select
‘
AT or ATX Mode
’
on MB jumper at first (refer to
Page
10
,
Pin(1-2) of AT_ COPEN
for AT Mode Select).
Case Open Detect
Use this item to detect case has already open or not, show message in POST.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], system will detect if COPEN has been short or not (refer to
Page-10
,
Pin (3-4)
of
AT_COPEN
jumper for Case Open Detection); if
Pin (3-4)
of
COPEN
is short, system will show Case Open Message during POST.
►
PC Health Status
Press [Enter] to view current hardware health status, make further settings in
‘
SmartFAN Configuration
’
and set value in
‘
Shutdown Temperature
’
.
►
SmartFAN Configuration
Press [Enter] to make settings for SmartFan Configuration:
SmartFAN Configuration
CPUFAN Smart Mode
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
CPUFAN Full-Speed Temperature
Use this item to set CPUFAN full speed temperature. Fan will run at full speed
when above this pre-set temperature.
CPUFAN Full-Speed Duty
Use this item to set CPUFAN full-speed duty. Fan will run at full speed when
above this pre-set duty.
CPUFAN Idle-Speed Temperature
Use this item to set CPUFAN idle speed temperature. Fan will run at idle speed
when below this pre-set temperature.
CPUFAN Idle-Speed Duty
Use this item to set CPUFAN idle speed duty. Fan will run at idle speed when
below this pre-set duty.
Shutdown Temperature
Use this item to select system shutdown temperature.
The optional settings are: [Disabled]; [70
o
C/158
o
F]; [75
o
C/167
o
F]; [80
o
C/176
o
F];
