© 2016 Jetta Corporation
.
All rights reserved. REV 08/2016
WWW.JETTACORP.COM
1(800) 288-7771
OWNER'S MANUAL
The bath should be filled 2” above the directional jets
BEFORE
turning on the pump.
Directional Body Jets:
To increase the directional jet pressure
, grasp the outer ring of the jet and turn
clockwise.
To reduce jet pressure,
turn the outer ring counter-clockwise.
To adjust the jet direction,
use your finger to position the jet nozzle
to the desired location.
To remove the jet
, grasp the outer ring of the jet and turn counter
clock- wise until the jet clicks, then pull jet out.
To install a jet
, insert the jet into the jet housing and turn clockwise
until the jet clicks. The jet will pass a point of resistance.
Do not force
the jet.
DESIGNER AND ELITE SERIES ONLY
Rotating Back Jets:
The upper rotating back jets can be shut down for operation at a lower
water level. When shut down, the rotating jets will still have a small
flow of water.
o
To increase rotation, use your finger to position the jet nozzle
closer to the outer ring
o
To decrease rotation, position the jet nozzle closer to the center of
the jet
Note:
When bathing is complete, the pump must be turned off and the bath emptied. Adjust the inner nozzle
portion of all the jets in a downward position while emptying the bath. This allows the bath to drain properly.
OPERATING INSTRUCTIONS
&/$66,&'(6,*1(5$1'(/,7(